内页banner

News Center

current position: Home > News Center > Company News

Formation of hot melt adhesive impurities and solutions

2022-01-06 15:50:42
times

Clean up the glue pot, improve the glue environment, and let the impurities of hot melt glue disappear. Before using the hot melt adhesive, there needs to be a process of melting the adhesive. During this process, there may be other impurities mixed in, for example, when binding a book with glue, some paper scraps and dust may fall into the glue pot.


Hot melt adhesive


The pot for melting glue will have more or less carbides deposited over the years, and may also be mixed with newly melted glue, etc. Maybe a little dust will not have much impact on the use and performance of hot melt adhesive, but what if the glue itself needs to match the appearance of the product? This requires special attention of glue users.


During the preparation of hot melt adhesive, the additives mainly include thinner, tackifier, plasticizer, filler and anti-aging agent.


The role of viscosity regulator is to reduce the viscosity of matrix, improve the fluidity during construction, control the curing speed and increase the wettability of glue solution on the joint surface. Diluents mainly include paraffin wax, microcrystalline wax, paraffin wax, plant wax, mineral wax and other wax compounds. Generally, the paraffin wax that is close to the melting point of the matrix should be selected. Because the melting point of the wax is too low, the heat resistance of the hot melt adhesive will be reduced. The solubility of ethylene vinyl acetate copolymer and wax compounds is greatly related to the content of vinyl acetate and the melting point of wax compounds. Generally, the solubility of wax compounds with large content of vinyl acetate is poor, and the higher the melting point of wax compounds, the worse the solubility.


The role of the tackifier is mainly to increase the bonding strength and flexibility of the hot melt adhesive film, and improve the wettability of the adhesive solution and the bonding surface. The commonly used tackifiers are rosin resin, terpene resin, petroleum resin, coumarone resin and oil soluble phenolic resin. The main component of rosin resin is C19H29COOH, which has more than ten isomers. It has good compatibility with ethylene vinyl acetate copolymer and other matrices. If the softening point is increased, it can be modified by polymerization, esterification and hydrogenation. The main component of terpene resin is (C5H8) n, which is also a variety of isomers. Terpene oil polymer and terpene phenolic polymer are commonly used.

Jiangmen Duokuaihaosheng Machinery Co., Ltd. specializes in R&D, production and sales of heat sealing tape, hot melt adhesive film and seamless fitting materials for medical protective clothing, outdoor sports clothing, footwear, casual wear, yoga clothing, luggage and other industries. Looking forward to your cooperation!

(Some materials of this website are from the network. If the information displayed on this website infringes your copyright or other legitimate rights and interests, please notify us in time, and this website will be deleted in time.)



Recently Viewed:

Related products

news.related_news

contact us

Address: No. 3, Fuye Street, Jiangmen, Guangdong

Tel:0750-3809010 / 3809017

E-mail:info@mfbshk.com / mfbs@mfbshk.com


      

WeChat             Online Service

Online Service

Verification:

More, faster,

better and cheaper
Seamless fit material

Hotline:

0750-3809010
0750-3809017

WeChat